G. Generator Housing, Installation and Mounting
G.3 Generator and exhaust assembly must be mounted and installed in the
designated locations where exhaust vapors are kept from entering the living area of
RV both from Generator housing, windows or other exterior source points. Failure
to adhere to warnings, clearance requirements and properly seal housing may result
in extreme bodily injury or death to installer or operator
G.4 Generator Housing must be constructed in accordance with all RVIA/ANSI,
NFPA and NEC construction standards and is required to meet all applicable state
and federal construction and safety requirements as well as your Manufacturers
internal construction and generator housing standards. Care should be taken to
inspect housing before and after installation to ensure complete integrity of housing
and corresponding seals. Any damage to housing may allow harmful vapors to
penetrate housing and enter inside living area of the RV.
G.5 Use the Generator Installation Bracket Floor Cut-out Template (See Exhibits 5
and 16) to verify the Bracket was made correctly and all holes and air intake and air
outflow areas are cut correctly
Page 23 of 55 Rev. 1
To Next Page