J. Fuel Connection
J.9 Locate the Purge Line from the RV (refer to your Manufacturer for model
specific location).
J.10 Locate the Fuel Line and Purge Line spout off the right side of the Generator
(below the rubber grommet for the Remote Start Wiring Harness and along side the
12Volt negative (-) ground connection. See Exhibit 10.
J.11 Slide the end of the RV purge line over the Generator Purge Line spout. See
Exhibit 10.
J.12 Secure tightly with the RV Manufacturer provided purge line clamp.
• In motorized RV applications, purge line will not be used and shall remain capped
as received from NPS.
J.13 Check connection for any leaks of fuel or vapors.
Page 45 of 55 Rev. 1
To Next Page