L. Initial Start-up
L.6 Start the Generator with the Hand-held Remote Start Keyfob, by depressing
the Start button (the indicator light next to the Start button should illuminate), if
operating properly, apply load and your NPS Generator is ready to be used
• If the indicator light on the Hand-held keyfob does not illuminate when you push the
button, try again. If it still does not illuminate or the Generator does not start, refer
to section "M. Troubleshooting."
L.7 Upon completion of the install do a final walk around of the Generator install
area, make sure area is clean and ensure all connections are tight and compartments
are secured properly.
Page 48 of 55 Rev. 1
To Next Page