Why NSK ENDO-MATE DT2 Dental equipment motor handpiece does not rotate?
If the motor handpiece does not rotate, check the motor handpiece cord connection. If the connection is correct, there may be a break in the motor handpiece or the motor handpiece cord, and you should contact your dealer.
What to do if NSK ENDO-MATE DT2 Dental equipment AC IN lamp does not light?
If the AC IN lamp doesn't light, check the AC adapter connection and ensure it's properly plugged into a working outlet with electricity. If the issue continues, the fuse or the AC adapter’s fuse may have burnt, and you should contact your dealer.
What to do if NSK dental equipment battery generates abnormal heat?
If the battery generates abnormal heat, replace it. If the new battery also generates heat, a circuit malfunction may be suspected. Contact your dealer in this case.
Why is my NSK ENDO-MATE DT2 Dental equipment motor overheating?
If the motor is overheating, it may be because a high load was continuously applied to the motor handpiece for a long time. If this happens, leave it until it cools down. If the issue persists, there may be a malfunction of the circuit, and you should contact your dealer.
What to do if NSK dental equipment power is not turned on?
If the power is not turning on, check the AC adapter connection and ensure it's plugged into a working outlet. Also, make sure the battery is not empty; charge it or use the AC adapter. If a battery is required, ensure it's properly inserted. If none of these steps work, the fuse may have burnt, in which case you should contact your dealer.
What does it mean when NSK ENDO-MATE DT2 Dental equipment displays a calibration error beyond the upper limit?
A calibration error beyond the upper limit suggests that the operating life of the motor handpiece or contra angle has expired. Replace the motor handpiece or contra angle head.
What to do if NSK dental equipment motor handpiece does not rotate and error code “E-1” is displayed?
If the motor handpiece does not rotate and error code “E-1” is displayed, the contra angle head may be clogged. Clean or replace the contra angle head. If the problem persists, there might be a short circuit inside the motor handpiece or the motor handpiece cord, and you should contact your dealer.
General| Motor Type | Brushless DC Motor |
|---|---|
| Speed Range | 100 - 1000 rpm |
| Display | LCD |
| Type | Endodontic Motor |
| Battery Life | Approx. 120 minutes |
| Power Supply | Rechargeable Lithium-ion Battery |
Summarizes critical safety warnings for device handling and operation across multiple pages.
Pre-treatment checks to ensure proper operation and safety.
Steps for calibrating the motor handpiece and contra angle head.
Basic steps for operating the device.
Explains the auto reverse function and its modes.
How to memorize and manage program settings.
Procedures for cleaning and disinfecting components.
How to lubricate the contra angle head using spray.
Steam sterilization process for the contra angle head.
Explains error codes and their causes/actions.
Common problems and solutions for the control unit and AC adaptor.
To Next Page
