Revision 1.03
Operation 5-15
5.9.4 RESTORE
The Restore option allows the user to
restore all factory defaults to the TX7.
Caution, all previously stored
changes will be erased from memory,
including Presets.
5.9.5 FREQUENCY
The Frequency option allows an ex-
perienced user to modify the frequency
plan utilized by the ChannelMaster TX7
using the front panel LCD. Extreme
caution should be used, since
changes will affect the RF function of
the unit.
5.9.6 FACTORY
The Factory Settings are to be used
by Nucomm authorized personnel
only! Any unauthorized tampering
could make the unit unstable or unus-
able.
5.9.7 BAS
For the BAS (formerly “NEXTEL”) sub-
menu, see Section 5.7: BAS Reloca-
tion Settings.
5.10 Monitoring Menu
Selections
5.10.1 MONITOR
The Monitor option allows the user to
monitor operational conditions of several
components while the unit is in use.
These include:
• PSU
• Temperature
• Modulator
• Upconverter
• Front Panel
NOTE: For PSU values, all voltages are
set to alarm at a condition of
± 10%.
Alarms are reported when errors occur
during the operation of the ChannelMas-
ter TX7. The alarm may be the result of
a detected broken communications link
or an improper input (etc.), and not the
fault of the unit itself. Regardless of the
problem, the Alarm LED will illuminate,
and the LCD will flash a text message
stating the alarm problem.
To Next Page
Loading...
