NVIDIA DGX H100 Service Manual
8.7. Integrate the New Drive and Complete
Installation
1. Return the motherboard to its regular position and power on the system.
Refer to Motherboard Tray - Opening and Closing the IO door for more information.
2. Boot the Operating System.
3. Run the following command to rebuild the boot drive mirror:
sudo nvsm start ∕systems∕localhost∕storage∕volumes∕md0∕rebuild∕
4. At the Type of volume rebuild prompt, enter raid-1 and press Enter:
PROMPT: In order to rebuild volume, volume type is required. Please
specify the volume type to rebuild from options below.
raid-0: create raid-0 data volume
raid-1: rebuild OS boot and root volumes
esp: find and replicate an empty EFI system partition
Type of volume rebuild (CTRL-C to cancel): raid-1
5. At the Name of spare drive prompt, enter the replacement drive name, nvme0n1 or nvme1n1,
and press Enter:
PROMPT: In order to rebuild this volume, a spare drive
is required. Please specify the spare drive to
use to rebuild RAID-1.
Name of spare drive for RAID-1 rebuild (CTRL-C to cancel): nvmeXn1
6. At the warning prompt, enter y and press Enter:
8.7. Integrate the New Drive and Complete Installation 53
To Next Page
Loading...
