UG8000-00 November 2002
Page 2-3
PREPARING FOR INSTALLATION
Follow the instructions in this section in the order given. If necessary, refer to the
general system descriptions and specifications in Section 1 of this manual for
additional information.
Installation generally includes mounting the frame in an equipment rack, making
connections to the frame, and checking and configuring the system using diagnostic
software.
Tools and supplies required for installation include the following:
• Equipment jack or an assistant to help with lifting.
•Rack screws
• Screwdriver for rack screws.
• Small screwdriver for RS-422 9-pin D connectors
• BNC Connector tool for tightly-spaced connectors
• Coaxial cables and connectors for equipment interconnections.
To Next Page
Loading...
Need help?
General
