Configuration—Motherboard
MPC5777C EVB User Guide, Rev. 1
10 NXP Semiconductors
By default the LIN interface is not enabled. To enable the LIN interface the jumpers detailed in
Table 4 need to be placed.
Table 4:
LIN control Jumpers
3.5 Ethernet Configuration
The EVB is fitted with a standard RJ45 Ethernet connector (J7) and a DP83848C 10/100
Ethernet transceiver (U6).
By default, the Ethernet interface is enabled. The Ethernet interface the jumpers are detailed in
Table
5
.
Table 5:
Ethernet control jumpers
PHY power(3.3V_SR) on (jumper
placed on default)
3.6 User Area
There is a rectangular prototype area on the EVB top right corner, consisting of a 0.1in. pitch array of
through-hole plated pads. Power from all the three switching regulators is readily accessible along
with GND through JP1 – JP16 next to the prototyping area. This area is ideal for the addition of any
custom circuitry.
To Next Page
Loading...
Need help?
General
