SAMM User Manual
45
7. Set mosaicking options or FLS or SLS data. For FLS data, set the arc and range, as well
as ground range(altitude data needs to be recorded) and invert beams. For SLS data,
set the minimum and maximum clipping ranges, ground range option and layback
options.
8. Set the gamma, brightness, horizontal feathering and vertical feathering of swaths.
9. Click Advanced Load.
10. Monitor file loading progress in the status bar on the bottom right. The swaths display as
each file is loaded.
6.1.3 Playback Files
Playback files option allows the user to replay the survey and watch mosaic being created with
user inputs such as breaking the swath at line turns and marking targets.
To Add data for playback mode:
1. Click the Add data icon.
2. Click Playback files.
3. Navigate to the directory containing the files (C:\SAMM_DEMO\demo_data).
4. Click on a file, then press Ctrl+A to select all of them. Note that you can only playback
data of the same format.
5. Click Open.
6. Monitor file loading progress in the status bar on the bottom right.
7. Click the Start button on the playback controls. The survey playback begins and mosaic
starts to build up.
6.1.4 Advanced Playback Files
Advanced playback files option allows the user to playback data files of the same type that are
stored in multiple locations as well as to specify mosaicking options (Figure 36).
To Next Page
Loading...