Oceanic SAMM - Toggle Display Units; Display Units Tutorial

SAMM User Manual
65
 The vessel slows down.
6. Drag it to the right.
 The vessel speeds up.
7. Drag the speed back to the middle (x1).
 The vessel returns to the normal speed.
8. Wait until the vessel turns. Then, in the toolbar, click the Manually start a new swath
button.
 data.1385510330801_039_ds.msk appears in the Swath list above
data.1385510330801_037_ds.msk.
9. Turn data.1385510330801_039_ds.msk on and off. Pay attention to what it looks
like.
10. Click data.1385510330801_037_ds.msk and then drag it over
data.1385510330801_039_ds.msk.
 data.1385510330801_037_ds.msk is layered over
data.1385510330801_039_ds.msk.
11. Turn off data.1385510330801_037_ds.msk.
 data.1385510330801_039_ds.msk is now visible.
12. In the main toolbar, click the Record icon.
 The boat moves without painting a swath underneath it.
 Text in the bottom left of the taskbar changes to Live.
13. Click Record again.
 SAMM paints the swath behind the vessel again.
 The text in the bottom left of the task bar changes back to Recording.
 data.1385510330801_039_ds.msk_2 appears in the Swath list.
14. Click on data.1385510330801_037_ds.msk and then click Delete.
 The swath disappears from the mosaic display. This does not affect the raw data (the
files in the folder that you added), but the swath is gone from this particular project
unless you add the source data file again.
15. Click on data.1385510330801_039_ds.msk_2, then click on it again. Enter Second
Swath.
 The name changes to Second Swath.
7.3 Toggle Display Units
Display units of parameters may be changed from the Configuration window. Section 4.2.3
described how to set the initial display units. This section provides a tutorial to supplement
Section 4.2.3.
7.3.1 Display Units Tutorial
This tutorial shows how to change position units from the Configuration window and toggle
position formats in the status bar.
1. Click the Configuration icon.
2. Click the Display tab.
3. Select Degree minute second from the Longitude/Latitude dropdown box.
 The position fields in the Live Info feed change to degree minute seconds.
 The cursor position unit correspondingly changes in the bottom right of the status
bar.
4. Click the Reset to International Standard (IS) units button to reset the default settings.