OFITE, 11302 Steeplecrest Dr., Houston, TX 77065 USA / Tel: 832-320-7300 / Fax: 713-880-9886 / www.ote.com 17
5. Prepare the cement slurry as stated in API Specication 10.
6. Pour the cement into the slurry cup through the open bottom of the
sleeve.
7. Place the metal o-ring around the threads of the base. Apply high-
temperature grease to the o-ring and base surface. Screw the base onto
the cup and tighten with the slurry cup tool.
The slurry cup should contain enough cement slurry that it leaks out of the
hole in the center of the base. If it does not, remove the base and rell the
slurry cup. Do not add cement through the hole in the base.
8. Screw the pivot bearing into the hole in the center of the base and tighten.
9. Wipe the entire slurry cup clean to ensure that no cement remains on the
outside.
Pivot Bearing
Slurry Cup Tool
Slurry Cup
Slurry Cup Stand
To Next Page
Loading...
