OfiTE 2025 - Page 6

OFITE, 11302 Steeplecrest Dr., Houston, TX 77065 USA / Tel: 832-320-7300 / Fax: 713-880-9886 / www.ote.com 5
#130-75-28 Allen Key,   ", 1¼" Long
#130-77-027-1 Pump
#141-28 Hose Kit
#141-15 Air Hose, 6', Qty: 2
#141-19 Air Hose Adapter, Qty: 6
#141-27 Drain Hose, Stainless Steel
#143-01 Gauge, 0 – 200 PSI
#171-45-4 Thermocouple, Bath (For Model 2025)
Potentiometer Components:
#120-602 Calibration Spring
#120-603 Potentiometer Body
#120-604 Potentiometer Resistor
#120-605 Contact Spring
#120-606 Potentiometer Contact Arm
#120-607 Contact Strip
#120-608 Grounding Cable Retaining Screw
#120-609 Grounding Contact Spring
Slurry Cup Components:
#120-501 Slurry Cup Sleeve
#120-502 Molded Diaphragm (For tests at or below 400°F)
#120-40-502 Diaphragm (For tests above 400°F)
#120-502-1 Flat Diaphragm, Buna (For tests below 200°F)
#120-503 Paddle Pin
#120-504 Pivot Bearing
#120-505 Pivot Bearing Gasket
#120-506 Paddle
#120-508 Diaphragm Retaining Ring
#120-509 Drive Disk
#120-510 Drive Bar
#120-512 Drive Pin
#120-513 Gasket for Bottom Cap
#120-514 Drive Disk Set Screw, 6-32 × 3, Stainless Steel
Optional:
#120-35-SP Spare Parts Kit
#120-001 Mineral Oil, 1 Gallon, Qty: 2
#120-102 Rupture Disk, 28,000 PSI, Qty: 2
#120-202 Heater, 4,000 Watt
#120-204 Heater Gaskets, Qty: 2
#120-208-1 Thermocouple for Slurry Cup, Qty: 2
#120-35-031 O-ring for Oil Reservoir, Viton, Qty: 2
#120-401-V O-ring for Cell Cap, Viton, Qty: 12
#120-501 Slurry Cup Sleeve
#120-502 Molded Diaphragm, Qty: 25
#120-503 Paddle Pin, Qty: 12
#120-504 Pivot Bearing, Qty: 6
#120-505 Pivot Bearing Gasket, Qty: 5
#120-506 Paddle for Slurry Cup, Qty: 4
#120-507 Paddle Shaft for Slurry Cup, Qty: 10