44205301TH Rev.1
193 /
Oki Data CONFIDENTIAL
7. Troubleshooting and repair procedure
Solution: Set the encryption strength to "Weak".
How to change encryption strength with Telnet
Note! Telnet cannot be used if it remains in the default setting. To change the
encryption strength,
Telnet must be set to Enable.
Sel
ect the command prompt (DOS prompt) and enter "Telnet <printer IP
address>", and press Return.
Establish connected using administrator user name and pass
word
Select the menus in this order: [4: Security Config] [5: Cipher (SSL/TLS)]
[2: Cipher Strength]. Then, change the cipher strength as desired (1: Strong, 2:
Standard, 3: Weak).
To Next Page
Loading...
