Oki C610N - Top Cover Assy

44205301TH Rev.1
68 /
Oki Data CONFIDENTIAL
4. Component replacement
4.2.9 Top cover Assy
(1) Remove the left side cover. (See section 4.2.3)
(2) Remove the right side cover. (See section 4.2.4)
(3) Remove the rear cover. (See section 4.2.6)
(4) Remove the plate shield and take the control PCB out. (See section 4.2.8)
(5) Remove the connectors of the stack full sensor cable and ID-FAN cable, remove
the connector and the hanging RFID cable
.
(6) Remove two E type stop rings
and two torsion springs , and remove the top
cover Assy
.
Note! Perform the following RFID circuit behavior check after replacement of the
top cov
er assy:
- By
executing RFID COLOR for the switch scan test described in 5.3.1.3,
check that the printer can display UID **H for each of cyan, magenta,
yellow and black with nonempty consumable cyan, magenta, yellow and
black toner cartridges installed in it.
- The pr
inter cannot detect the UID usage for a color with a starter toner
cartridge installed for the color. Note the printer’s starter cartridge
for a color cannot be reinstalled in it once replaced with an empty
consumable toner cartridge for the color.