沖データ企業秘密・OkiDataCONFIDENTIAL
45530603TX −109／130
Priority
Status Message Ready
LED
Atten
LED
Function Status level
Error code
Status code
indicate paper orientation after Paper Size.
304 1
2
3
Change %MEDIA_SIZE% %MEDIA_TYPE% in
MPTray
Press OK Button
Please see HELP for details
Off Blink
The size of paper or media type in the tray does not match the print data.
Load paper in tray
(It takes a while until the status disappears after you have closed the tray and the lever
lifted.)
Error 460 : MPTray
The paper size displaying form of the custom mode is the same as above.
Paper size displays in Custom mode: "<width>x<length> <unit>"
ex.) 210x297 mm
8.5x11.0 inch
A user needs to press ONLINE key after changing the paper.
If Media_Size has both portrait and landscape, %MEDIA_SIZE% displays icon which
indicate paper orientation after Paper Size.
Error
460
480yy
305 1
2
3
Press OK Button for Restoration
Memory Overflow
Off Blink
Memory capacity overflows due to the following reason.
Press ON-LINE switch so that it continues. Install expansion RAM or decrease the data
amount.
- Too much print data in a page.
- Too much Macro data.
- Too much DLL data.
- After frame buffer compression, over flow occurred.
Error
420
30097
306 1
2
3
Protec Paper Error Off Blink
This error occurs if a received job does not meet the security level designated by a printer
administrator. A printing operator is not using the printer driver that is specified by a
security manager of the printer.
Displays a warning on the operation panel as waiting for key press. Does not print the job
that is being processed. (The same operation as job reset)
Error
421
30966
307 1
2
3
Protec Paper Error Off Blink
Density of the destination image for a woven pattern is greater than that of the woven
pattern. A user must take measures such as increasing density of the woven pattern or
decreasing density of the input image.
Displays a warning on the operation panel as waiting for key press. Does not print the job
that is being processed. (The same operation as job reset)
Error
422
30967
308 1
2
3
Trust Paper Error Off Blink
This error occurs when capacity of specified information to be embedded exceeds the
capacity that can be embedded in the woven pattern. A printing operator must reduce data
to be embedded in the woven pattern.
Displays a warning on the operation panel as waiting for key press. Does not print the job
that is being processed. (The same operation as job reset)
Error
423
30968
309 1
2
3
Trust Paper Error Off Blink
Density of the destination image for woven pattern is greater than that of the woven
pattern. A user must take measures such as increasing density of the woven pattern or
decreasing density of the input image.
Displays a warning on the operation panel as waiting for key press. Does not print the job
that is being processed. (The same operation as job reset)
Error
424
30969
310 1
2
3
Trust Paper Error Off Blink
The area specified for tampering verification is incorrect.
This error occurs when an image is pushed away or the unprintable area is specified.
Error
425
30965
311 1
2
3
Protec Paper Error Off Blink
Size of information to be embedded is greater than paper size. It is required to reduce
information to be embedded or increase print paper size to make prints.
Error
426
30964
312 1
2
Protec Paper Error Off Blink
NTP server setting is not correct. Print JOB is canceled because it judged that the correct
time is impossible to enter. Users need to change the setting of NT server.
Error
427
30960
To Next Page
Loading...
