4
4-18 Performing Setup from the Control Panel
IPX/SPX Setup options
For protocols other than IPX/SPX, the frame type is automatically enabled and does
not require setup, as follows:
To specify the frame types the Fiery uses for IPX/SPX protocols, choose IPX/SPX
Setup from the Protocol Setup menu. You must choose at least one frame type to
enable IPX/SPX protocols. The Fiery supports the following frame types for
IPX/SPX:
• For Ethernet—Ethernet 802.2, Ethernet 802.3, Ethernet II, and Ethernet SNAP
With this protocol And these printing services
This frame type is
automatically enabled
AppleTalk PAP (Printer Access Protocol) Ethernet SNAP
TCP/IP with Ethernet LPD (Line Printer Daemon) Ethernet II
To Next Page
Loading...
