141 Using the Scanner
4 Press the up or down arrow key to select CHECK/EDIT, and then press the
Enter key.
5 Press the up or down arrow key to select the address to be deleted from the
favorite list, and then press the Stop/Reset key.
6 Press the up or down arrow key to select YES, and then press Enter key.
The selected address is deleted.
7 To delete another address, repeat the procedure from step 5.
8 To finish deleting addresses, press the Back key.
9 Press the up or down arrow key to select FINISH, and then press the Enter
key.
Registering Speed Dial Destinations (Direct Input)
E-mail addresses can be registered as speed dial destinations. A maximum of
250 speed dial destinations can be registered.
" Machine key operations cannot be used to register an FTP address or
SMB address as a speed dial destination. These addresses can be regis-
tered with the Setup Utility.
" Speed dial destination numbers 221 to 250 are reserved for registering
FTP addresses and SMB address from the Setup Utility.
1 In the main screen (Scan mode), press the up or down arrow key to select
UTILITY, and then press the Enter key.
2 Press the up or down arrow key to select DIAL REGISTER, and then press
the Enter key.
3 Press the up or down arrow key to select SPEED DIAL, and then press the
Enter key.
4 Use the keypad to type in the number (between 1 and 220) for the speed dial
destination, and then press the Enter key.
5 Press the up or down arrow key to select MANUAL SETTING, and then press
the Enter key.
" If an LDAP server is not specified, step 5 is skipped.
6 Use the keypad to type in the registration name, and then press the ENTER
key.
" For details on entering/editing text, refer to “Entering Text” on
page 265.
" A maximum of 20 characters can be entered.
To Next Page
Loading...
Need help?
General
