92 Media Handling
About Duplex Printing
Duplex (double-sided) printing can be performed when the duplex option has
been installed on this machine.
" For details on installing the duplex option, refer to “Duplex Option” on
page 253.
If the paper has low opacity (high translucency), then the printed data from one
side of the page will show through to the other side. Check your application for
margin information. For best results, print a small quantity to make sure the
opacity is acceptable.
Note
Only Letter/A4 plain paper, 60–90 g/m
2
(16–24 lb bond) can be
autoduplexed. See “Print Media” on page 77.
Duplexing labels, letterheads or thick stock is not supported.
How do I autoduplex?
Check your application to determine how to set your margins for duplex
(double-sided) printing.
The following Binding Position settings are available.
If “Short Edge Binding” is selected, the pages will be laid
out to flip at the top.
If “Long Edge Binding” is selected, the pages will be laid out
to flip at the side.
1
3
1
2
1
1
1
1
1
2
3
To Next Page
Loading...
