Oki MC361 User Manual

12
Menu Item 1 Item 2 Item 3
Service Bit
Country Code
Tone Send Test
DP Send Test
MF Send Test
Line Test
Modem Signal Send
Test
Fax
Maintenance
*This menu not shown
on models with no fax.
T.30 Monitor Execute
IBM 5577
IBM PPR III XL
Personality
EPSON FX
Print Maintenance
Engine Diag Mode
2.3 System Maintenance
OKIUSER
Sets the MFP for the Destination Country.
Note! Should always be set for ODA (North America). Settings other than ODA may
result in erratic MFP operation. When the screen exits the service menu after this setting
is changed, the MFP reboots automatically.
Format SD Card
A confirmation message is displayed when the Enter switch is pressed.
When "No" has been selected, the system returns to the previous menu.
When "Yes" has been selected, the menu is exited and formatting of the inserted SD card
begins.
Displayed under the following conditions:
SD card inserted ("Boot Menu" - "Storage Setup" - "Enable SD Card" is Yes)
Format Flash ROM
Caution! Use of this command is strictly prohibited (contact design before use).
When this command is executed, the menu is exited and formatting of the resident
(onboard) flash device begins.
Reset Admin Password
Returns the administrator password to the factory default value.
All Reset
Returns the content of EEPROM, flash, and the HDD to their factory default values.
When this command is executed, the following confirmation message is displayed: "This
change will reboot the device automatically. Proceed?"
When "No" has been selected, the system returns to the previous menu.
When "Yes" has been selected, the menu is exited immediately and then, after rebooting,
reset processing begins. See the "format scope" sheet for the scope of formatting.

Oki MC361 Specifications

Printing Specifications

print speed color	23 ppm
print speed black & white	25 ppm
time to first page color	9 seconds
time to first page black & white	8.5 seconds
print resolution	1200 x 600 dpi

Copying Specifications

copy speed color	23 cpm
copy speed black & white	25 cpm
first copy out color	14 seconds
first copy out black & white	12 seconds
copy resolution	600 x 600 dpi

Scanning Specifications

scan resolution	1200 x 1200 dpi
scan speed color	3 sec./page
scan speed black & white	2 sec./page

Fax Specifications

fax modem speed	33.6 Kbps
transmission speed	3 seconds/page
fax resolution	200 x 400 dpi

Power and Environment

power consumption operating	500W
power consumption max	1170W
power consumption idle	100W

Weight and Dimensions

size	16.8" x 20" x 17.5"
weight	63 lb.
weight with consumables	29 kg