Oki MC361

Motor & Clutch Restrictions
Unit name displayed Driving restriction Remarks
ID MOTOR
All of the (black, yellow,
magenta and cyan) image drums
must be removed.
–
BELT MOTOR
All of the (black, yellow,
magenta and cyan) image drums
must be removed.
–
FUSER_MOTOR – –
REGIST MOTOR – –
T1 HOPPING MOTOR – –
FRONT MOTOR – –
REGIST SHUTTER – –
DUPLEX MOTOR – –
DUPLEX CLUTCH – –
T2 HOPPING MOTOR – Option
T2 FEED CLUTCH – Option
ID UP/DOWN
The top and front cover must be
closed.
–
LV FAN TEST – –
ID FAN TEST – –
FRONT FAN TEST – –
Note: Display while ID UP/DOWN is in progress
***: Identifies the number of executions
Display after holding down REGIST SHUTTER [6] button
***: Identifies the number of executions
2.8.3 Test Print
The test printing is used for printing test patterns stored in the PU. The controller stores
the other patterns.
The test printing cannot be used to check print quality.
1. Enter the self-diagnostic mode and, until TEST PRINT appears on the upper
display, press [2] or [8] ([2] displays the next test option and [8] displays the
preceding option). Then press the [6] button.
2. A setting option applied only to test printing appears on the lower display. Press
[2] or [8] until a target option appears ([2] displays the next option and [8]
displays the preceding option). Then press the [6] button. [Go to step 5 when the
options do not need to be set (left set to their defaults)].
27