T.30 Monitor
The unit keeps the last transmission log (Tx/Rx commands) on volatile memory, and
print when select "Execute".
If turn off the unit, the records will be lost.
Personality
IBM 5577 Values: Enable / Disable
IBM PPR III XL Values: Enable / Disable Default: Enable
EPSON FX Values: Enable / Disable Default: Enable
Engine Diag Mode
See Section 2.7
2.8 Engine Diagnostic Mode (Self-Diagnostic)
How to enter self-diagnostic mode
Note! The initial Password is set to "000000" (Six zeros).
1. When the equipment is in standby mode, access the password entry screen by
pressing [Setting] # 0 1 0 3 *
2. Press the Down Arrow until Printer Maintenance is highlighted and press OK
3. Arrow down to Engine Diag Mode and press OK
00.06.08 = PU Firmware
Version
S-Mode = Shipping Mode
Press either [2] key or [8
] key to move to the respective self-diagnostic items.
(Menu item scrolls when either [2] key or [8] key is pressed.)
Press the [6] key to execute the selected test. Exit the test by pressing the [4] key.
19
To Next Page
Loading...
