Upper Display Lower Display Format Unit Detail
K OVER RIDE
CNT
********TIMES Decimal Times
Y OVER RIDE
CNT
********TIMES Decimal Times
M OVER RIDE
CNT
********TIMES Decimal Times
C OVER RIDE
CNT
********TIMES Decimal Times
Each displays the extension life
count of a toner cartridge.
2.8.7 Print counter display
The print counter display is used for viewing print counter values.
1. Enter the self-diagnostic mode and, until PRINTER STATUS appears, press [2]
or [8] ([2] displays the next test option and [8] displays the preceding test option).
Then press the [6] button.
2. Press [2] or [8], and each count is printed (the [*] or [#] button is disabled).
3. Press [4] to end the option (the state for step 1 is restored).
Upper Display Lower Display Format Unit Detail
K –
IMPRESSIONS
********IMAGES Decimal Images
Y –
IMPRESSIONS
********IMAGES Decimal Images
M –
IMPRESSIONS
********IMAGES Decimal Images
C –
IMPRESSIONS
********IMAGES Decimal Images
Number of printed sheets for
each color is displayed.
TOTAL SHEET
CNT
********COUNTS Decimal Prints Total number of printed sheets
is displayed.
2.8.8 Factory/Shipping Mode Setting
The Factory/Shipping mode setting is used for switching from the Factory to Shipping
mode.
1. Enter the self-diagnostic mode and, until the following message appears, press [2]
or [8].
2. Press [2] or [8] and the following message appears. Press [2] or [8] until an option
to set (refer to the table shown below) appears.
3. By pressing the [6] button with the option on the display, a setting for the option
can be selected.
36
To Next Page
Loading...
