3. The setting option and its setting appear on the upper and lower displays,
respectively. Pressing [2] displays the next setting and pressing [8] displays the
preceding setting (the setting last displayed is applied. Press [4] to accept the
setting and return to step 2. Repeat step 3 when necessary.
Display Setup Value Function
PRINT EXECUTE -
Starts’ printing with the press of [6] button, and ends
printing with the press of the [#] button.
TEST PATTERN 0
0: Prints a blank page.
1 to 7: - See the next section (pattern printing)
8 to 15: Each prints a blank page.
TRAY1
TRAY2
TEST CASSETTE
MPT Tray
Selects a paper source.
TRAY2 is not displayed when the tray 2 is not
installed.
PAGE 0000 Sets the number of test copies to print.
ON
COLOR
OFF
Selects color or monochrome printing.
* ON and OFF are provided for each color when the
setting ON is specified.
2 PAGES STACK Performs duplex printing using a two pages layout.
OFF Selects turning off duplex printing.
DUPLEX
1 PAGES STACK Performs duplex printing using a one page stack layout.
Default is in shaded areas (XXX). Set settings are enabled only in this test mode (not
written into the EEPROM)
Note:
PAGE: Moves its input digit with [2] or [8]. The setting for this option is incremented by
pressing the [*] button, and decremented by pressing the [#] button. Note that, when left
set, the setting 0000 endlessly prints pages.
COLOR: When set to ON, with the press of the [6] button, displays the information
shown below.
Setting option for printing colors: Moves its input position with [2] or [8]. The setting for
each color is switched between ON and OFF by the press of the [*] or [#] button. The
panel display is restored to the previous one by pressing [4].
4. With PRINT EXECUTE displayed on the lower display by the operation in step
2, pressing the [6] button executes test printing by using the setting(s) made in
steps 2 and 3.
The test printing is cancelled by pressing the [#] button.
When detected in starting or performing the test printing, an alarm shown in the
detail section of the following list is displayed on the operator panel, stopping the
printing.
28
To Next Page
Loading...
