Oki MC361

14
Adjust Scan Position
FBS – Side Reg. Value: +8 ~ -8 Default: 0
Adjust the starting read pixel position in the horizontal scanning direction during
book scanning.
Adjust in intervals of one step = 4/600 dpi (=0.17 mm).
FBS – Front Edge Value: +30 ~ -30 Default: 0
During book scanning, add a value for the basic value (= 5 mm) when reading the
shadow of the front edge of the document.
Adjust in intervals of one step = 4/600 dpi (=0.17 mm).
ADF (Front-side) – Side Reg. Value: +8 ~ -8 Default: 0
Adjust the starting read pixel position in the horizontal scanning direction when
reading a document from the ADF.
Adjust in intervals of one step = 4/600 dpi (=0.17 mm).
ADF (Front-side) – Front Edge Value: +30 ~ -30 Default: 0
When reading a document from the ADF, add a value for the basic value when
reading the shadow of the front edge of the document. To skip the front edge of
the document, add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of
the front edge of the media until actual reading starts.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
ADF (Front-side) – Back Edge Value: +30 ~ -30 Default: 0
When reading a document from the ADF, add a value for the basic value when
skipping the back edge of the document. To read the shadow of the back edge of
the document, add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of
the back edge of the media until actual reading ends.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
ADF (Back-side) – Front Edge Value: +30 ~ -30 Default: 0
When reading a document from the ADF, add a value for the basic value when
reading the shadow of the front edge of the document. To skip the front edge of
the document, add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of
the front edge of the media until actual reading starts.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
ADF (Back-side) – Back Edge Value: +30 ~ -30 Default: 0
When reading a document from the ADF, add a value for the basic value when
skipping the back edge of the document. To read the shadow of the back edge of
the document, add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of
the back edge of the media until actual reading ends.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
Adjust ADF Scan Position Value: +30 ~ -30 Default: 0
Set the CIS reading position of the ADF for the focusing standard.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm). This is correlated to
adjustment of the ADF front edge position.