ML1120/ML1190 User’s Guide - Operating instructions > 56
MENU ITEM FUNCTION SETTING
Parallel I/F I-Prime Set I-Prime signal control
of the Centronics interface.
Invalid
Buffer Print
Buffer Clear
Auto Feed XT
Set whether to enable
or disable Auto Feed XT
signal of the Centronics
interface.
(EPSON emulation only)
Valid
Invalid
Bi-Direction Set whether to enable
or disable Two-way
communication of the
Centronics interface.
Enable
Disable
Serial I/F Parity Set parity.
None
Odd
Even
Ignore
Serial Data 7/8
Bits
Set serial data length.
8 bit
7 bit
Protocol Set protocols.
DTR
X-ON/X-OFF
DTR & X-ON/X-OFF
Diagnostic Test Set/Cancel loop testing of
the serial interface.
No
Yes
Baud Rate Set the transmission speed
of the serial interface.
9,600 bps
4,800 bps
2,400 bps
1,200 bps
600 bps
300 bps
19,200 bps
DTR Signal Set whether to switch
the DTR signal of the
serial interface by Select/
Deselect or hold it after
power-on.
Ready on Power UP
Ready on Select
Busy Time Set the minimum time it
takes to switch from a busy
state to a ready state.
0.2 sec
1.0 sec
To Next Page
Loading...
