ML1120/ML1190 User’s Guide - Troubleshooting > 76
PROBLEM CAUSE ACTION
Paper distortion or jam. Forms are loaded with their
left holes out of line with
the right ones.
Load forms with their left
holes in line with the right
ones.
Inadequate distance
between the left and right
Pin Tractors, making for
loose paper.
Relocate the Pin Tractors to
tighten the paper.
Paper movement is
blocked.
Remove the blockage.
Paper source is too far
from the printer.
Move the paper source nearer
to the printer.
Paper not specified for the
printer.
Use paper types specified for
this printer.
Several blank lines
appear in the printout.
Skip over perforation
spacing is selected.
Cancel the skip over
perforation spacing.
The selected skip over
perforation spacing does
not match the physical
tear-off perforation
positions.
The paper length selected
in the application does not
match the physical paper
length.
Match the paper length
selected in the application
with the physical paper length
in use.
Select the paper length
in number of lines in the
application.
Abnormal switchover between cut sheet and continuous forms modes.
No cut sheet feed. The printer is in continuous
forms mode.
Set the Paper Type lever to
cut sheet mode.
No continuous forms
feed.
The printer is in cut sheet
mode.
Set the Paper Type lever to
continuous forms mode.
Paper feed operations
for both cut sheets and
continuous forms are
actuated.
The cut sheet is not
ejected.
Eject the cut sheet.
To Next Page
Loading...
