Oki ML5720 User Manual

Operating instructions > 52
Set-up
cont.
Paper End
Detection
Select whether to detect
paper end or not.
Change to OFF to
override the sensor and
print closer to the
bottom of the page.
On
Off
-
Print Registration
1
Adjust the print starting
position on printing in
the reverse direction.
(The position moves to
the right or left in 1/720
in increments.)
-10 ~ -1
0
+10 ~ +1
Print Registration
2
Adjust the print starting
position on printing in
the reverse direction.
(The position moves to
the right or left in 1/720
in increments.)
-10 ~ -1
0
+10 ~ +1
Print Registration
3
Adjust the print starting
position on printing in
the reverse direction.
(The position moves to
the right or left in 1/720
in increments.)
-10 ~ -1
0
+10 ~ +1
Print Registration
4
Adjust the print starting
position on printing in
the reverse direction.
(The position moves to
the right or left in 1/720
in increments.)
-10 ~ -1
0
+10 ~ +1
7 or 8 Bits Data
Word
Select data word
lengths.
7
8
-
Operator Panel
Function
Select full or limited
operation.
Full Operation
Limited Operation
Reset Inhibit Changing this to Yes
prevents a reset signal
from the computer from
resetting the printer to
its defaults.
No
Yes
Print Suppress
Effective
Select whether to enable
or disable a print
suppress setup
command.
No
Yes
Auto LF Select whether to
perform auto LF
operation or not upon
receiving a CR code. If
your print out is
consistently double
spaced, select No, if it
overprints, select Yes.
No
Yes
Auto CR
(Displayed only for
IBM emulation)
Select Yes to add a
carriage return when a
Line Feed is received at
the end of a line.
No
Yes
GROUP ITEM FUNCTION SETS
ML5720/ML5721 ML5790/ML5791

Oki ML5720 Specifications

General

Brand	Oki
Model	ML5720
Category	Printer
Language	English