Oki ML690 - Loading Continuous Forms Paper

ML690/ML691 User’s Guide 15
Loading Continuous Forms Paper
To avoid paper feeding problems:
Make sure the printer is on a surface
approximately 30” (76 cm) above the oor.
Position the continuous forms supply directly
below the printer, no more than 1.2” (3 cm) left
or right of the printer paper path.
Make sure the rear of the printer is close to and
parallel with the edge of the surface and at least
24” (61 cm) from any wall.
There are three ways to load continuous forms paper.
See the following pages for instructions.
Rear feed
rear




Front feed
front
Bottom feed (optional pull tractor)
bottom

