Oki ML690 - Tearing Off Continuous Forms Paper

ML690/ML691 User’s Guide 22
down to take up slack. Slack will cause the line
spacing to be inconsistent. Turn the platen to
help remove the slack.
pulltractor-cover-close-A
Close the access cover.
Turn the printer ON.
Press the LF/FF key to feed paper to the tractor.
NOTE: If the TOF position shifts because of taking
up slack, press the LF/FF key to set the TOF
position. Do not use the platen knob for this
option as this will cause irregular line spacing.
12.
13.
14.
Tearing Off Continuous Forms Paper
With the SEL indicator illuminated, press the TEAR
key to feed the continuous forms to the tear-off
position.
Carefully tear off the forms along the tear-off
perforations in the direction shown.
When data is received by the printer or when
the SEL key is pressed to select the printer, the
continuous forms is repositioned to the rst line
print position.
Aligning the Tear-Off Perforations
If the tear-off perforations are not aligned with the
paper cutter on the access cover, align them as
follows:
With the SEL indicator illuminated, press the TEAR
button to move the tear-off perforations to the
paper cutter on the access cover.
Check the position of the tear-off perforations
relative to the paper cutter. Adjust to the desired
tear-off position using the 1/180” line feeds (LF).
- To move the form forward, press and hold the
TEAR and SEL keys at the same time, then
release the keys.
- To move the form backward, press and hold the
1.
2.
3.
1.
2.