Oki ML690 - Resetting the Menu to the Factory Defaults

ML690/ML691 User’s Guide 42
Resetting the Menu to the Factory
Defaults
Note: Please print the current Menu Mode settings
before you reset or change them. This is the only
way to have a record of the settings.
To reset the Menu to the standard settings (factory
defaults):
Turn the printer off.
Press and hold down the SEL and LF/FF keys at
the same time while turning the printer ON.
The SEL light will ash.
Press and hold down the TEAR key and then
press the SEL key again to put the printer online.
1.
2.
3.
Entering and Exiting Menu Mode
To activate Menu Mode:
Press the SEL key to take the printer ofine (the
SEL light will turn off).
Hold down the CHR PITCH key and press the
PRINT SPEED key. This toggles the menu on (i.e.,
“enters” the menu) and makes the GROUP, ITEM,
SET, and PRINT keys active.
Use the GROUP, ITEM, SET, and PRINT keys to
perform the functions as described in the Menu
Mode Keys and Functions table.
To turn Menu Mode off:
Hold down the CHR PITCH key and press the PRINT
SPEED key. This toggles the menu off (i.e., “exits”
the Menu).
1.
2.
3.
1.