ML690/ML691 User’s Guide 20
Make sure the tractor assembly is in the front of
the printer. If the tractor is in the back, remove
the sheet guide, grab the nger guides (1) on
each side and pinch them together to release the
guide. Remove it from the back and insert it into
the front feed and when it is seated, push down
to snap the guides in place. Replace the back
sheet guide.
Pull up on the lock levers to release them and
allow the tractor sprockets to slide back and
forth.
You will nd reference marks on the printer for
the most common paper sizes.
Move the left tractor to the position to match
your paper size and push back on the lever to
lock it in place, then move the right tractor to t
the width of the paper.
Open the tractor covers and place continuous
forms paper on the rst two pins of either tractor,
5.
6.
7.
8.
9.
then close the left tractor cover.
Important!
Be sure that both sides of the paper have the same
number of paper holes engaged on the sprocket pins.
If you don’t the paper will skew and jam.
Adjust the position of the right tractor to center
the holes in the paper on the pins. Then, close
the tractor cover and push back the lock lever. Do
not stretch the paper.
Note: If the paper is too loose or too tight it can cause
jams.
fronttractor-cover-close-20-70
10.
1
1
To Next Page
Loading...
