Oki ML690 - Page 53

ML690/ML691 User’s Guide 53
MENU SETTINGS TABLE
Group Item Function Settings (defaults are set in bold italic)
Pull
(cont.)
Page Length Specify the length of a continuous
form.
3” (76.2 mm), 3.25” (82.6 mm),
3.33” (84.7 mm), 3.5” (88.9 mm),
3.66” (993.1 mm), 4” (101.6 mm),
5” (127 mm), 5.5” (139.7 mm), 6”
(152.4 mm), 7” (177.8 mm), 8”
(203.2 mm), 8.5” (215.9 mm), 11”
(279.4 mm), 11.7” (296.3 mm),
12” (304.8 mm), 14” (355.6 mm),
17” (431.8 mm)
LF Revise (Continuous
Paper Line Feed Adjust)
For continuous feed, adjusts the
line feed to the specied amount.
–2, –1, 0, +1, +2
Centering Position Used to limit printhead travel
when printing narrow columns.
Select Mode 1 for ML690. Select
Mode 1 or Mode 2 for the ML691.
Default, Mode1, Mode2
Cut Sheet
Top Feed
Line Spacing Change to 8 lines per inch (lpi) to
get more lines on a page.
6 LPI, 8 LPI
Form Tear-Off
5, 6
(Displayed when
connected to RPS)
Specify manual form paper
advancement or select a time;
when printer is idle for .5, 1 or
2 seconds, paper is advanced
from the current print position to
the tear position. When data is
received, paper is moved to its
original printing position.
Manual, 0.5 sec, 1 sec, 2 sec