Oki ML690 - Page 63

ML690/ML691 User’s Guide 63
MENU SETTINGS TABLE
Group Item Function Settings (defaults are set in bold italic)
Set-Up
(cont.)
Sleep Mode Default setting saves power by
having the printer go into sleep
mode; when disabled the printer
never goes into sleep mode.
Enable, Disable
Sleep Time Set the idle time before the printer
enters sleep mode (when Sleep
Mode is enabled).
5 min, 10 min, 15 min, 30 min, 60
min
Pin Control Regulates the striking force for
multi-part forms. For single
sheets, use “Standard”; for multi-
part forms, use “Special.”
Standard, Special
Pin Control Select Regulates the striking force for
multi-part forms. For single
sheets, use “Mode1”; for multi-
part forms, use “Mode2.”
Mode1, Mode2
Paper End In default setting when paper end
is detected, printer remains on-
line; if set to Off-line, when paper
end is detected, printer goes off-
line.
On-line, Off-line
FF Function Set the feeding operation upon
receiving an FF code after cut
sheet paper is fed.
Eject, Form Feed