Oki Data CONFIDENTIAL
43627911TH Rev. 3
134 /
Table 5-0. Maintenance Menu Display Table (2/2)
Category Item Value DF Old Menu Function
Vailid Save
Maintenance
Menu
Format HDD Execute - "SYSTEM
MAINENANCE
MENU" –
"MAINTENANCE
MENU" – "HDD
INITIALIZE"
Initialize the HDD. When executed
it will escape from the menu and
start initializing the HDD.[Display
Condition]
ET -
• Mount HDD ("Boot Men
u"-
"Storage Setup"- "Enable
Initialization "Enable, "Boot
Menu"-"Storage Setup"-"Enable
HDD" Yes)
F
orma
tFlash
ROM
NEXT - "SYSTEM
MAINENANCE
MENU"-
"MAINTENANCE
MENU" – "FLASH
INITIALIZE"
This displays the menu to initialize
the Flash ROM.
* Do not use this Menu.
RB -
Reset
EEPR
OM
Execute - "SYSTEM
MAINENANCE
MENU"-
"MAINTENANCE
MENU" –"MENU
RESET"
This resets the EEPROM details to
the factory preset (factory default)
value. It automatically reboots after
the settings are made and applied.
* Some special items are not
initialized.
RB -
Personality IBM PPRIII
XL
Enable
Disable
*E
*J
"SYSTEM
MAINENANCE
MENU"-
"PERONALITY" –
"IBM PPR III XL"
Changes the default PDL language
supported according to the
destination.The PDL language
disabled from this menu will no
longer be displayed on the "Print
Setup" – "Personality" of the
Function menu. When receiving print
data in the disabled PDL language,
display "INVALID DATA" and
dispose the incoming data. (HP-
GL/2 is currently under development
and there are no plans scheduled
for application for the product).
PDF requires Adobe Postscript,
therefore, it is not possible to turn
PDF ON/OFF by itself (if Adobe
Postscript is DISABLED, the PDF
Function will also be DISABLED).
It is not possible to DISABLE Adobe
Postscript and PDF with PX711/713.
(It shall be usually used in the
ENABLE state. Though DISABLE
is set the incoming data will still be
processed. It has been incorporated
for future extension purposes.)
-
EPSONFX Enable
Disable
*E
*J
"SYSTEM
MAINENANCE
MENU"-
"PER
ONSALITY"
–
"EPSON fx"
ET -
HP-GL/2 Enable
Disable *JE
"SYSTEM
MAINENANCE
MENU"-
"PERSONALITY"
– "hp-gl/2"
ET -
IBM5577
During the Engine Self-Diagnosis Mode, switch operations and the LCD display is instructed by the
engine firmware, therefore, it will vary from the specifications of the controller firmware operations.
Note that the Engine Self-Diagnosis Mode can also be executed in the state with the controller
PCD removed.
For details, accordingly refer to the Engine Specifications Manual.
To Next Page
Loading...
Need help?
General
