Oki Data CONFIDENTIAL
43627911TH Rev. 3
164 /
5.2.6 Precautions in HDD Replacement (1200 dpi printer)
HDD storage values are used for various set ups, such as network and model serial No. etc. in
1200dpi printer (EFI model.) If HDD is changed due to a trouble shooting or error message, it is
necessary to re-setup the user set information, which has not saved in the EEPROM after coping
the information stored in the EEPROM PCB into HDD.
See below for the procedure.
Configuration print should take place before a change or addition of HDD.
(It is used for reference for later resetting.)
Change HDD (keep the power off to execute.)
Execute the factory default (see 5.2.7 for details)
(Information stored in the EEPROM PCB such as the model name and P&P will be cop-
ied into HDD.)
Execute configuration print. Re-setup if not corresponded to the result of .
The removed HDD shall be returned to the ODC (JPN/AOS), ODA (North America), OEL (EMEA).
The HDD label is very expensive, as the royalty fee is included. Take great care in handling it.
The royalty fee varies from program to program (GA is more expensive than Std). Make sure the
program is correct
To Next Page
Loading...
Need help?
General
