50
T
Replacing the Roll Paper
LP-1040/LP-1040-MF User's Manual for Basic Printer Operation
2
Move the ange guide.
Align the ange guide with the position
appropriate for the roll paper size.
3
Flange guide Paper ange
Set the roll paper into the Printer.
Hold the roll paper so that the paper end hangs
down from the bottom toward the Printer. Slowly
insert the paper ange while aligning it with the
groove on the ange guide.
Note
Be careful not to drop the roll paper.
4
Insert the end of the roll paper inside
the paper inlet.
By manually rotating the paper ange, feed the
roll paper.
5
Paper feed knob
By rotating the paper feed knob, feed
the roll paper so that a the top of the
roll paper protrude from the printer by
approximately 60 cm (23.63 inch).
60 cm
(23.63 inch)
Before Use Basic Operations Menu Functions
Authentication
Function
Print Job Box
Function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
5
4
6
To Next Page
Loading...
