51
T
Replacing the Roll Paper
LP-1040/LP-1040-MF User's Manual for Basic Printer Operation
6
ロール紙の交換
ᤶ㒌
Replacing Roll Paper
4
6
1
32
用紙カット位置
Paper Cut Position
ߛ㒌ԡ㕂
7
5
Cutter
While holding the end of the roll paper,
cut the paper with the cutter.
The Paper Cut Position label is axed to the
left end of the groove for the cutter edge.
Insert the edge of the cutter in the groove above
the label and cut the paper by moving the cutter
along the groove.
Caution
Be careful not to injure yourself on the cutter.
Note
After closing a roll paper drawer, do not open it again until the Warming
up… (Warming-up counter) message disappears.
When you set a roll paper of a dierent type or series, press Paper on
the supply paper error screen. Set the type and the series of the new
paper roll on the paper setting popup screen which appears.
7
Close the roll paper drawer.
Hold the handle and slowly push in the drawer
for rolls 1 and 2. (It takes about 30 seconds for the
paper feeding to get ready.)
When the Printer contains the jobs to be
completed, the printing is started.
Before Use Basic Operations Menu Functions
Authentication
Function
Print Job Box
Function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
5
4
6
To Next Page
Loading...
