5 Load the paper stack with the recommended print side faceup.
6 Make sure the paper guides are secure against the edges of the paper.
Note: Make sure that the side guides are placed tightly against the edges of the paper so that the image is
registered properly on the page.
7 Insert the tray.
8 If a different type or size of paper was loaded than the type or size previously loaded in the tray, change the Paper
Type or Paper Size setting for the tray from the printer control panel.
Note: Mixing paper sizes or types in a paper tray may lead to jams.
Loading the 650-sheet duo drawer
The 650-sheet duo drawer (Tray 2) consists of a 550-sheet tray and an integrated 100-sheet multipurpose feeder. The
drawer is loaded in the same way as the 250-sheet tray and supports the same paper types and sizes. The only
differences are the look of the guide tabs and the location of the paper size indicators, as shown in the following
illustration:
Loading paper and specialty media
47
To Next Page
Loading...
Need help?
General
