ENGLISH
9
4. The first field Language is highlighted. Check if the language indicated is the language you require for the cash
register. If it is, proceed to the next step, otherwise change the language by pressing until the language you
want is displayed, then press .
5. Press to position on the next field, PLU/EJ Memory. Here you can set the maximum number of PLUs that
can be stored on the cash register and the type of memory to use for storing Electronic Journal data, either the
internal memory of the cash register or a removable Storage Device (SD). If you are using an SD card, the number of
lines that can be stored depends on its capacity. For example, a 1GB card provides storage for 40 million transaction
lines. Choose one of these combinations:
•
1500 PLU numbers & max 12000 lines stored internal memory
•
2000 PLU numbers & max 11000 lines stored internal memory
•
3000 PLU numbers & storage on memory card only
Press until the combination you want is displayed, then press .
If you choose to store the journal on the SD card, you must configure also the EJ System option (see “Electronic
Journal”).
6. Press to position on the prompt: Are you sure? Press until YES is displayed, then press
. The cash register is reset with the values you have programmed.
SETTING THE DATE FORMAT
1. Press to activate the menu system.
2. Select
Programming Mode -> Configuration Setup -> Initial Setup -> Date FORMAT.
3. Press until the date format you require is displayed.
4. Press .
SETTING THE DATE
1. Press to activate the menu system.
2. Select
Programming Mode -> Configuration Setup -> Initial Setup -> Date setup.
3. Type the current date in the format you have selected.
4. Press .
NOTE: The date format can be changed at any time. Refer to the section "Setting the Date Format".
SETTING THE TIME FORMAT
1. Press to activate the menu system.
2. Select
Programming Mode -> Configuration Setup -> Initial Setup -> Time system.
3. Press until the time format you require is displayed.
4. Press
.
To Next Page
Loading...
