Olivetti ECR 7900 - Counter Settings

ENGLISH
25
COUNTER SETTINGS
Select Programming Mode -> Configuration Setup -> Counter Settings. Navigate to the field you want to personalize and
enter its data (see “Data Entry Mode” for the keys to use). At the end, you can press to return to the Main
menu or to return to the previous menu.
Manager mode 0000 to 9999 4-digit password to protect access to Manager mode. Default: 0000 (not
activated).
A password can be set up for the cash register Manager: the user authorized
to perform all sales transaction functions.
NOTE: During transaction entry, if a clerk is not enabled to perform a
certain type of operation (such as a VOID or REFUND), an
authorized operator can intervene, pressing to enter
Manager mode, and entering the Manager password if it is
programmed. After performing the required operation, the
operator can log off by pressing
again. At this point,
the Clerk can continue with the transaction and terminate it in
the normal way.
Training mode 0000 to 9999 4-digit password to control activation of Training mode. Default: 0000 (not
activated).
When a password is setup, a normal clerk or the Manager can activate
Training mode, outside of a transaction, by entering: (password)
.
The same sequence can be used to exit Training mode (see “Activating and
Disactivating Training Mode”).
Menu Item Possible Values
Description
Receipt Number 1 to 9999 Max. 4-digits to specify from which number to start sequentially numbering
receipts.
Z1 Counter 1 to 9999 Z1 Financial report counter. Max. 4 digits indicating number from which to
start Z1 counter. You can override the cash register's default Z1 financial
report counter by programming the number from which you want the
counter to start counting consecutively each time a financial report is
printed.
Z2 Counter 1 to 9999 Z2 Financial report counter. Max. 4 digits to specify number from which to
start Z2 counter. You can override the cash register's default Z2 financial
report counter by programming the number from which you want the
counter to start counting consecutively each time a financial report is
printed.
GT Value (Numeric) Grand Total value. Max.12 digits to specify Grand Total. You can program
the transaction grand total value printed on the management reports.
Receipt# Reset YES, NO Receipt number reset. YES - Enable, NO - Disable.
Z1&2 CT Reset YES, NO Z1 and Z2 counter reset. YES - Enable, NO - Disable.
GT Reset YES, NO GT counter reset. YES - Enable, NO - Disable.
Menu Item Possible Values
Description