SETUP from the Operator Console 3-3
Parameters (for printers with serial interface)
The parameters that can be selected using the setup are grouped in the way illustrated
below, which is also how they are printed by the machine:
-------------------------------------------------------------------
EMULATION
EMULATION: TM-U950 - TM-950
I/O
I/O: SERIAL - EXIT
SERIAL: BIT
BIT: 8 - 7
SERIAL: BAUD
BAUD: 9600 - 4800 - 2400 - 1200
SERIAL: STOP
STOP: 1 - 2
SERIAL: PARITY
PARITY: NONE - ODD - EVEN
SERIAL: HANDSHAKE
HANDSHAKE: DTR - XON/XOF
........SERIAL: RX ERROR
RX ERROR: PRINT "?" - NO PRINT
I/O: EXIT
USER
USER: NATION - CPI - OTHER - EXIT
USER: NATION
NATION: CP 437 - CP 850 - CP 860 - CP 863
CP 865 - CP 866
USER: CPI
CPI: 12.5 - 16.6
USER: OTHER
OTHER: CUTTER
CUTTER: YES - NO
.........OTHER: EPSON CUTTER
EPSON CUTTER: YES - NO
.........OTHER: CHEQUE PRINT
CHEQUE PRINT: REAR - FRONT
OTHER: DISPLAY
DISPLAY: DISABLE - ENABLE
OTHER: AUTO LF
AUTO LF: NO - YES
OTHER: RECEIVE BUFF.
RECEIVE BUFF.: 32 - 2048
OTHER: BUSY OFFLINE
BUSY OFFLINE: YES - NO
OTHER: RS PIN 6
RS PIN 6: DISABLE - ENABLE
OTHER: RS PIN 25
RS PIN 25: DISABLE - ENABLE
USER: EXIT
SAVE
SAVE: PRINT - SAVE - DEFAULT - RESTART
-------------------------------------------------------------------
See also the section:
Notes and Meaning of the Parameters
To Next Page
Loading...
