3-6 SETUP from the Operator Console
How to select the parameters
After access to the setup - see the section How to Access the Setup, the machine prints the
first main menu "EMULATION" (for printers with serial interface).
At this point there are two alternatives:
1. If you press key 2 - JOURNAL (you select the menu), the machine prints the first
parameter of this menu "EMULATION: TMU 950".
2. If you press key 1 - RECEIPT (you do not select the menu), the machine prints the
second main menu "I/O".
Assuming your selection was 1, there are again two alternatives:
a If you press key 2 - JOURNAL (you select the parameter EMULATION: TMU 950), the
machine prints the second main menu "I/O".
b If you press key 1 - RECEIPT (you do not select the parameter EMULATION: TMU
950), the machine prints the “ EMULATION:” alternative "TM 950".
...... and so on.
To summarize:
1. In setup mode, the machine prints and proposes one item or one parameter at a time.
2. The item or parameter can be accepted and selected with key 2 - JOURNAL or refused
with key 1 - RECEIPT.
To Next Page
Loading...
