Epson TM-U950 Commands 4-19
ESC E n
Turn emphasized mode on/off
Hexadecimal code: 1B 45 n
Range:
n = 0-255 (Only the lowest bit of
n
is enabled)
Turns emphasized mode on or off.
Notes:
-
When the LSB of
n
is 0, emphasized mode is turned off.
-
When the LSB of
n
is 1, emphasized mode is turned on.
- 2-pass printing is slower in emphasized mode.
- This command and ESC ! turn on and off emphasized mode in the same way. Be careful
when this command is used with ESC !.
Default:
n = 0
References:
ESC !
ESC G n
Turn on/off double-strike mode
Hexadecimal code: 1B 47 n
Range:
n = 0-255 (Only the lowest bit of
n
is enabled)
Turns double-strike mode on or off.
Notes:
-
When the LSB of
n
is 0, double-strike mode is turned off.
-
When the LSB of
n
is 1, double-strike mode is turned on.
- Printer output is the same in double strike and in emphasized.
Default:
n = 0
References:
ESC E
ESC J n
Print and feed paper
Hexadecimal code: 1B 4A n
Range:
n = 0-255
Prints the data in the print buffer and feeds the paper [
n
x vertical motion unit] inches.
Notes:
- After printing is completed, this command sets the print starting position to the beginning
of the line.
- The maximum paper feed amount that can be set is 40 inches. If the specified amount
exceeds 40 inches, the paper feed amount is automatically set to 40 inches.
-
If
n
is out of the range, this command is ignored.
References:
GS P
To Next Page
Loading...
