Introduction/Conformity Standards Operation/Maintenance Manual
6. Conformity Standards
(1) This equipment is carrying out conformity or evaluation to the following standard.
(2) Although this equipment aims at using in the industrial environment, since it may not satisfy
a performance when not used by the right operation method, please carry out the proper
handling according to this manual.
FCC
This product has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference when the product is operated in a commercial environment. This product generates, use,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications.
Operation of this product in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
SEMI
This equipment is carrying out evaluation to the guideline of the following SEMI standard.
・ S2-1016: Safety Guidelines for Semiconductor Manufacturing Equipment
・ S8-1016: Safety Guidelines for Ergonomics Engineering of Semiconductor Manufacturing Equipment
For Korea only
이 기기는 업무용 환경에서 사용할 목적으로 적합성평가를 받은 기기로서 가정용
환경에서 사용하는 경우 전파간섭의 우려가 있습니다.
This equipment is an object for industrial environment (Class A). Other
equipment may be affected if it is used in a housing environment.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the product.
FCC Supplier's Declaration of Conformity
Hereby declares that the product
Product name: Semiconductor Wafer Loader, Semiconductor Wafer Loader and Accessory
Model Number: AL120-LMB12-LP3
Conforms to the following specifications:
FCC Part 15, Subpart B, Section 15.107 and Section 15.109
Supplementary Information:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Responsible Party Name: Olympus Scientific Solutions Americas Corp.
Address: 48 Woerd Ave Waltham, MA 02453, U.S.A.
Phone Number: 781-419-3900
To Next Page
Loading...
