41
EN
Shooting
2
• When set to [p (Digital ESP metering)] (P. 45, 51), metering is performed with priority given
to faces.
• Face priority is also available in [MF] (P. 43, 51). Faces detected by the camera are indicated
by white frames.
Zoom frame AF/Zoom AF ( Super Spot AF)
You can zoom in on a portion of the frame when adjusting focus. Choosing a high
zoom ratio allows you to use autofocus to focus on a smaller area than is normally
covered by the AF target. You can also position the focus target more precisely.
• To use Super Spot AF, you must fi rst assign [U] to a button with Button Function (P. 66).
3030
250250 F5.6
0.00.0
L
N
S-IS AUTO
S-IS AUTO
ISO-A
200
FHD
F
60
P
1:02:031:02:03
100
%
Shooting display
3030
250250 F5.6
L
N
S-IS AUTO
S-IS AUTO
ISO-A
200
FHD
F
60
P
Off
1:02:031:02:03
100
%
0.0
Zoom frame AF display
100
%
Zoom AF display
U
U
U
U (Press and hold)
/
Q
1
Press and release the U button to display the zoom frame.
• If the subject has been focused using autofocus immediately before the button is
pressed, the zoom frame will be displayed at the current focus position.
• Use FGHI to position the zoom frame.
• Press the INFO button and use FG to choose the zoom ratio. (×3, ×5, ×7, ×10,
×14)
2
Press and release the U button again to zoom in on the zoom frame.
• Use FGHI to position the zoom frame.
• You can change the zoom ratio by rotating the front dial (r) or rear dial (o).
3
Press the shutter button halfway to initiate autofocus.
• The camera will focus using the subject in the frame at the center of the screen. Use
FGHI to choose a different focus position.
• Zoom is visible only in the monitor and has no effect on the resulting photographs.
• While zoomed in, a sound is made by the IS (Image Stabilizer).
To Next Page
Loading...
