Olympus IPLEX G Lite - Using the AC Adapter; Charging the Battery

■ Removing the battery
Remove the battery by moving the tab at the
battery insertion slot in the direction indicated
by the arrow.
2
Using the AC adapter
Follow the steps below to
connect the AC adapter.
① Open the DC-IN terminal
cap on the main unit.
② Connect the AC power
cord to the AC inlet of the
AC adapter.
③ Connect the output
connector of the AC
adapter to the DC-IN
terminal of this
instrument.
④ Then, connect the plug of
the AC power cord
securely to a power outlet.
3
Charging the battery
●
When the AC adapter is connected, turning off the power starts charging the battery. (Charging
is not performed when the power is on.)
●
The charging indicator appears blinking when charging is in progress.
●
If you want to stop charging halfway, disconnect the AC adapter.
●
The light of the charging indicator goes off when charging is complete.
●
Disconnect the AC adapter when the battery is fully charged.
Ta b
AC inlet
DC-IN
terminal cap
IPLEX G Lite
23