43
Chapter 3 Preparation and inspection before observation
2 When attaching the control unit to the back of the main unit, check
that it is positioned as shown in the figure below before attachment.
Then, check that the control unit is firmly attached. Attaching it with
excessive force in the wrong direction can cause the control unit to
fall off and cause an accident. This also may damage the main unit.
3 Push in the hanger until you feel a click. If it is not inserted
completely it may come off too easily.
4 When detaching the control unit from the main unit, pull the control
unit straight upward from the main unit. When the control unit is
affixed to the back of the main unit, hold down the center of the lock
release button as you pull upwards.
Correct direction
Incorrect direction
Incorrect direction
To Next Page
Loading...
