52
Chapter 4 Basic operations
Checking the LCD monitor image
1 Ensure that the LCD monitor displays the observation image.
2 Make sure there are no dark patches or dirt in the image. If you find
any irregularities, go back to “3.4 Inspecting the insertion tube”
(page 31) and “3.6 Inspecting the optical adapter” (page 35) to
check it again.
NOTE
• The screen displays and menu operations are enabled approximately 40 seconds after the
power button ( ) is pressed.
• When the language setting is changed, the time taken until the screen display functions, such
as menu selection, may be longer than before. This is not a malfunction.
• When using the stereo optical adapter, the position of the left and right images may be
misaligned in some direction or at an angle depending on the assembly of the optical adapter
and the insertion tube, but this is not a malfunction.
• The displayed title is the title that was entered on the Live screen the last time the system
was used.
Indicator display
Battery indicator
Sequence number
Brightness level
Zoom level
Date/time Title
Freeze indicator
Logo
Optical adapter name
(4-mm, 6-mm, and 8.5 type LXs only)
Hi-Beam
indicator
(LX only)
Temperature
indicator
(LX only)
Gain mode
(LX only)
Light indicator
Recording/playback indicator
To Next Page
Loading...
