56
Chapter 4 Basic operations
CAUTION
• The [ANGLE] joystick may allow to control the articulation portion of insertion tube precisely
while the [ANGLE LOCK] lever is pulled.
However, if the angle lock is on, do not do extreme angle operations.
Doing angle operations while the angle lock is on may cause an overload malfunction.
• While the angle is locked by pull up the [ANGLE LOCK] lever, the “LOCK” label shows up on
the [ANGLE LOCK] lever. If the operation of articulation getting heavier during operation,
please check the “LOCK” label is shown or not. If the “LOCK” is shown, by pull down the
[ANGLE LOCK] lever to release the [ANGLE LOCK] status which will then get back to normal
mode.
• Take care not to lose the stopper.
To Next Page
Loading...
