DMTA-20043-01EN [U8778624], Rev. B, May 2013
Important Information — Please Read Before Use 13
Korea Communications Commission (KCC)
A 급 기기 ( 업무용 방송통신기자재 )
이 기기는 업무용 (A 급 ) 전자파적합기기로서 판 매자 또는 사용자는 이 점을주의하시
기 바라 며 , 가정외의 지역에서 사용하는 것을 목적으로 합니다 .
EMC Directive Compliance
This equipment generates and uses radio-frequency energy and, if not installed and
used properly (that is, in strict accordance with the manufacturer’s instructions), may
cause interference. The OmniScan SX has been tested and found to comply with the
limits for an industrial device in accordance with the specifications of the EMC
directive.
To maintain OmniScan SX compliance with the emissions requirements of the EMC
directive, the following conditions must be met:
• All cables used to connect the equipment must have an overall shielding to ensure
electromagnetic compatibility and optimal performance.
• Ferrite clamp filters must be attached to the cables connected to the OmniScan SX.
For details, see “Ferrite clamp filters” on page 43.
FCC (USA) Compliance
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance with the
instruction manual, might cause harmful interference to radio communications.
To Next Page
Loading...
